how to use CGDI MB

October 31, 2018 Eva Auto key Programmer 0

Procedures:

Remove the transmission control unit from vehicle.

CGDI-MB-1

Open the CGDI MB software,select “Auto Computer”,and select “TCU”

CGDI-MB-2

Select “Wiring Diagram”

CGDI-MB-3

According the CGDI MB wire diagram to connect transmission control unit to CGDI MB.

CGDI-MB-4

EraseReprogram Benz Transmission Control Unit5

Click “Read”

CGDI-MB-5

Then CGDI MB Prog from obd2tool.com will show the transmission control unit information in the “Module Information” section.

CGDI-MB-6

Click “Get” to get erase password
CGDI-MB-7

Erase password calculated successfully!

CGDI-MB-9

Here it will show the erase password,and you need to click “Erase”

CGDI-MB-10

Erase successfully

CGDI-MB-11

Now click “Read” button to check the transmission control unit information,it show the it was erased.

CGDI-MB-12

Done!

Related posts:

  1. 3 steps to do MB SCN Coding Online easily by Autel MS908P
  2. How to Reset Benz ME9.7 ECU with CGDI Prog MB Benz?
  3. How to Renew Benz W204 used ELV with CGDI MB
  4. Replace BMW CAS3 D80 Engine Computer by CGDI BMW

Be the first to comment

Leave a Reply

Your email address will not be published.


*