Instruction: How to program remotes for HONDA CIVIC 2018 by Autel IM608 programmer.
Go to Autel IM608 IMMO software
Accept the agreement
Honda – Manual selection – Civic – Touch tone smart card
Immo status scan
Is the ignition on by pressing the start button twice
No fault
Autel is gonna to add a smart key
Registration condition:
there are no DTCs
there must be one registered keyless remote
one keyless remote that is capable of starting the engine must be in the vehicle
the ignition switch must be turned on (II) using the keyless remote (the ignition key must not be used)
Notes when registering
Ensure the following to reduce noise as much as possible during keyless remote registration:
Turn off all electrical devices (e.g. navigation and audio systems) Separate the diagnostic tool from the keyless remote as much as possible. Close all doors, windows and sunroofs.
Please turn the ignition switch off
(Dont press the foot brake and press the engine start/stop button)
Pls wait for the ECU to stablise
Remove all other keyless access remotes from the vehicle
Pls take on registered keyless access remote into the vehicle
Please turn the ignition switch on
(Dont press the foot brake and press the engine start/stop button twice)
Vehicle condition checking…
Take all original keyless access remotes out of the vhicle
Take a new keyless access remote into the vehicle
This keyless access remote is now registered
Please turn the ignition switch off
(Dont press the foot brake and press the engine start/stop button)
Pls wait for the ECU to stablise
Please turn the ignition switch on
(Dont press the foot brake and press the engine start/stop button twice)
Are both the keyless access and immobilizer indicator lights turned off?
Please turn the ignition switch off
(Dont press the foot brake and press the engine start/stop button)
Pls wait for the ECU to stablise
Please turn the ignition switch on
(Dont press the foot brake and press the engine start/stop button twice)
The registration is completed
Please turn the ignition switch off
(Dont press the foot brake and press the engine start/stop button)
Pls wait for the ECU to stablise
Check all keyless access remotes to ensure each will start the engine
Check all keyless access remotes to sure each will lock and unlock doors
Please turn the ignition switch on
(Dont press the foot brake and press the engine start/stop button twice)
Immo status scan
Job’s done!
Leave a Reply