How to Read and Write Data for Bench or Boot
Recently, some customers gave feedback that they cannot find the appropriate guide and pinout for their ECUs in the PCMTuner Magic Car Tool (as shown […]
Auto ECU Programmer
Which one is the best remote generator and key programmer
Which one is the best remote generator and Key Programmer? What’s the difference between them? Here we have collected hot 5 key tools in 2022, […]
How to Use PCMTuner Read and Write VAG DQ200 DQ250
Question: I can’t read VAG DQ200 Gearbox TCU with pcm tuner. Why do I have gray buttons when reading and writing? Have the same problem […]
How to Read Trouble Codes via BlueDriver
This guide will show you how to read error codes with BlueDriver as well as how to interpret the scan results. BlueDriver is a vehicle […]
PCMTuner ECU Progarmmer Update TO V1.22
PCMTuner ECU Progammer software was updated to v1.2.2 on April 12, 2022. This update is not about the features, it is just an update to […]
IS PCMTuner Better than KTM200?
IS PCMtuner Better than KTM200? Maybe a lot of people have questions about this, I just received PCMTuner recently, I would like to share it with […]
How to use CGDI FC200 ECU Programmer to clone Audi Gearbox DL382 data
How to use CGDI FC200 ECU Programmer to clone Audi Gearbox DL382 data? Audi gearbox clone only supports to do on bench, NOT support OBD […]
How to Install LED BDM Frame Kit for Kess Ktag
This article is a guidance of the installation of LED BDM Frame and BDM Frame for Ktag Kess. Why we need BDM Frame？ In some […]
Edc17cp14 read and write with Ktag 7.020 clone Confirmed
More and more users tried to read and write ecm edc17cp14 using Clone V7.020 KTAG Master with Red PCB. Review 1. Can confirm that ktag […]
Mitsubishi MUT 3 VCI Diagnostic System Review
I kept the clone Mitsubishi MUT III (Multi Use Tester v3) diagnostic and programming system for over half a year. The original direct from SPX the […]