This is the procedure on how to use CGDI Prog Benz Monster to reset/renew Benz ME9.7 ECU.
Procedures:
Build wire connection between ME9.7 ECU,CGDI MB programmer and computer
Open CGDI Benz software,click “Wiring Diagram”,then select “ECU”à”ME9.7” to check the your connections are correctly.
Select “Auto Computer”,then click “Read”
After reading process completing,you can see vehicle information on the software.
Click “Get” to get erase password
Wait for process…
Erase password calculated successfully
After then click “Erase” button
Erase successfully
And now you can read the ECU information again to check ME9.7 status.
Done!
Leave a Reply