How to Reset Oil on 2012 Peugeot 308 by Launch X431 Scanner

Which launch X431 scanner can reset oil service for 2012 Peugeot 308? How to do?

Issue: the maintenance lamp appears on the dashboard of 2012 Peugeot 308

Solution: reset oil service using Launch X431 scanner such as X431 Pro or X431 V+

Step-by-step guide:

Connect Launch X431 V or Launch X431 PRO3 with the OBD port of the vehicle

Select “Reset”-> “OIL RESET”


Note: The software is used for oil rest. After the maintenance completed, the driven mileage or the travel time should be reset to zero so that the maintenance lamp will go out and the system will apply a new maintenance cycle at the same time.

Select car brand “MERCEDES-BENZ”

Turn the ignition switch on

Select “Software Reset”

Then it will read VIN and car model

Select “Automatic Scan”-> “Maintenance indicator reset”

Note: The resetting of the service indicator must be carried out with the ignition on, engine not running.

Press “OK” to continue

Pay attention to the prompt:

The service indicator must be reset to zero at the mileage recommended in the vehicle’s servicing schedule. This zero reset procedure can be carried out manually without the diagnostic equipment.

Press “OK” to continue

Reset maintenance indicator successfully

Read out VIN, mode, car model and system number

Switch off the ignition and then switch on again

Finally, remove the VCI from the vehicle

Be the first to comment

Leave a Reply

Your email address will not be published.


*