2018 Toyota Camry Cluster Calibration and key programming by OBDSTAR X300 DP PLUS

This article show a guide on how to use OBDSTAR X300 DP PLUS to perform all keys lost programming and Cluster Calibration for Toyota 2018,It is tested 100% ok.

Car models: 2018 Toyota Camry

Tool: OBDSTAR X300 DP PLUS

Part 1. OBDSTAR X300 DP Plus program Toyota 88/8A All Key Lost with simulated card
Part 2. 2018 Toyota Camry Cluster Calibration by OBDSTAR X300 DP PLUS

Part 1. OBDSTAR X300 DP Plus program Toyota 88/8A All Key Lost with simulated card

Connect OBDSTAR DP Plus (OBDSTAR X300 PAD2)to the Toyota OBD port (Directly charge via the vehicle)
Press the “Start” button and you can see the yellow warning light flashes for 3 times (Means detecting no keys).


Enter into DP Plus function menu, tap “Toyota / Scion / Lexus”

Initializing MCU data
Loading
VCI is upgrading.. (VCI is built-in)
Initializing
Loading
Initializing diagnostic data
Authorizing…
* 5 seconds done… DP plus is running fast
Tap “Smart key system”

Tap “Type 5 (All smart keys lost)”

Tap “Read eeprom”.

Read in on-screen guide :

This function can read (backup) vehicle EEPROM data;
After read (backup) of vehicle eeprom data, the simulated card is generated with this data;
Using simulated card attach start button to illuminate instrument, and instead of original car key to [Add smart keys].

Communicating…
Reading data…
Please reenter the file name to save.


This vehicle EEPROM data backup was successful. Please execute the [Make Simulated Card] function!

Tap “Make Simulated Card”.

This function can generate an simulated card with all keys lost.
Use this simulated card instead of the original car key to approach the start button and turn on the instrument, and perform the [Add Smart key] operation.
Make sure the simulated card is fully charged, otherwise the [Add Smart key] operation may fail.


This function is available by connecting the server, please ensure the internet connection is normal.

Connecting to the server.
Connect P001 programmer to diagnostic tool.


Put NO.3 simulated card (Red) into P001 programmer.

Insert the battery and turn on the switch.


Put the simulated card (88/A8 type in Red) into P001 programmer.

Only one seconds later, get message:
Generating simulated card successfully.

Move the simulated card close to the start button and try to light the meter. If you can light up the meter normally, use the simulated card instead of the original car key for the [Add smart key] operation.



Go on [Add smart key] operation.
Done

Part 2. 2018 Toyota Camry Cluster Calibration by OBDSTAR X300 DP PLUS

Obdstar x300 dp plus is confirmed to be able to calibrate the cluster for a 2018 Toyota Camry. This post will show the mileage calibration procedure.

Plug the obdstar x300 dp plus into the OBD2 port of the 2018 Toyota Camry.

Tap “Diag Program”.

Cluster calibrate -> Toyota.


Toyota V30.20.
Tap ” Camry”.

2018 VDO.

Mileage calibration.

Old value: 36290KM, press “Enter” to continue.

Input 36298KM new value.

The dashboard will light off and then light on again, you will see 36298KM. And obdstar x300 dp plus will have message “Calibration complete” on the screen.



Job is done.

 

Add a Comment

Your email address will not be published. Required fields are marked *