Autel MaxiDiag MD808 PRO Service

The Autel MD808 Pro Scan Tool provide Oil Reset EPB SAS, DPF and BMS functions for most modern vehicles on the road today. Select the Service function from the Main Menu to access the five special functions.

18-1

Oil Reset

The Engine Oil Life System calculates when to change the engine oil and filter based on vehicle use. An oil change is required whenever indicated by the display and according to the recommended maintenance schedule. Whenever the oil is changed, reset the system so it can calculate when the next oil change is required. If a situation occurs where the oil is changed prior to a service indicator being turned on, also reset the system.

IMPORTANT:Always reset the engine oil life to 100% after every oil change.

NOTE:All required work must be carried out before the service indicators are reset. Failure to do so may result in incorrect service values and cause DTCs to be stored by the relevant control module.

Reset Operation

Select Oil Reset icon on the Service screen {Figure 5-1) and wait for the vehicle manufacturer screen. Choose the correct vehicle make.

There are two ways to perform the reset service.

Manual Reset:
Almost all Asian vehicles and most American and European vehicles can be reset manually by technicians.

NOTE:
In this manner, the scan tool will not communicate with the vehicle being tested.
To finish this procedure, please follow these steps (Take Ford as an example):
1) Select Ford from the vehicle make screen and press OK
2) Select the right options for your vehicle step by step according to each screen that appears until the vehicle information is identified.
3) After entering the vehicle information, the scan tool will display a manual reset message, press OK to continue.
4) Follow the instructions to reset the service manually.
5) Press ESC to exit.

Auto Reset
Most American and European vehicles can be reset automatically by the Car Diagnostic Tool.

NOTE:
In this manner, the scan tool will communicate with the vehicle being tested. If there is a linking error, please refer to Product Troubleshooting on page 15 for details._
To finish this procedure, please follow these steps (Take Peugeot as an example):
1) Select Peugeot from the vehicle make screen and press OK
2) Select the right options for your vehicle step by step according to each screen that appears until the vehicle information is identified.
3)After entering the vehicle information, the OBD2 Scan Tool displays manual reset message as below:

18-2

Read Codes
Please refer to Read Codes on page 72 for details.

Erase Codes
Please refer to Erase Codes on page 73 for details.

Maintenance
Select Maintenance function ad press OK button. The screen will display the preset maintenance information of the vehicle. The information items vary with different vehicles.

18-3
Press Config.to enter the edit screen of this table

18-4

For Period before Servicing (Month(s)) or Maintenance limit, press Edit to open a soft keyboard to facilitate your input.
The three keys at the bottom of the screen work as below:
[Finish]: After entering the value, use this key to save the value to the tool.
[Edit]: Press this key to edit the value of each field.
[Esc]: Press this key to exit.

Press Yes to save the data and continue.

NOTE:
The data you input should within the reasonable range, which is defined by the preset values in the ECU. If the input data is out of range, the tool will display a warning message of “Input Overflow!”

For the First service threshold, there are two choices. Select the correct one and press OK to save the change.

18-5

When the configurat ion is completed, press Finish on the bottom of the screen to continue.

Be the first to comment

Leave a Reply

Your email address will not be published.


*